Free tool
Bridge formula calculator for semi truck weight limits
On the US Interstate System, a truck may weigh up to 80,000 lb gross, 20,000 lb on a single axle and 34,000 lb on a tandem, and every group of axles must also stay under the federal bridge formula. Enter the spacing and weight of each axle, and the tool shows the maximum for every axle group and flags any group that is over.
Filled in with FHWA's example truck (steer axle 12,000 lb, four axles at 17,000 lb). Replace it with your own truck.
Measure centre to centre. In feet, 8 ft 6 in is 8.5. Leave the weights empty to see only the limits.
Federal weight limits
- Maximum for axles 1 to 5 (51 ft)
- 80,000 lb (36,287 kg)
- Your weights
- 1 limit exceeded
| Axles | Length | Max (lb) | Actual (lb) |
|---|---|---|---|
| 1 to 2 | 16 ft | 40,000 | 29,000 |
| 1 to 3 | 20 ft | 51,000 | 46,000 |
| 1 to 4 | 47 ft | 73,500 | 63,000 |
| 1 to 5 | 51 ft | 80,000 | 80,000 |
| 2 to 3 | 4 ft | 34,000 | 34,000 |
| 2 to 4 | 31 ft | 59,000 | 51,000 |
| 2 to 5 | 35 ft | 65,500 | 68,000 (over by 2,500) |
| 3 to 4 | 27 ft | 40,000 | 34,000 |
| 3 to 5 | 31 ft | 59,000 | 51,000 |
| 4 to 5 | 4 ft | 34,000 | 34,000 |
Rules applied: 20,000 lb on any one axle, 34,000 lb on axles more than 40 in and not more than 96 in apart, 80,000 lb gross, and the bridge formula on every group of two or more consecutive axles, rounded to the nearest 500 lb (down when exactly halfway, as in FHWA's table). The length is taken in whole feet, rounded down, which matches FHWA's bridge table. Two tandems 36 ft or more apart may carry 34,000 lb each.
US Interstate System only. Grandfathered state limits, permits and the idle reduction allowance are not included. In Canada, provinces and territories set their own limits.
Checked November 5, 2026.
Sources: 23 CFR 658.17, Weight (ecfr.gov/current/title-23/chapter-I/subchapter-G/part-658/section-658.17) and FHWA, Bridge Formula Weights, FHWA-HOP-19-028, August 2019 (ops.fhwa.dot.gov/freight/publications/brdg_frm_wghts). The regulation takes precedence over this tool.
Why check the bridge formula
A truck can be under 80,000 lb and still be overweight. The bridge formula limits how much weight a group of axles may carry for its length, so a short wheelbase with heavy axles close together fails even when the gross is legal. Checking before a load leaves the yard tells you whether to move weight, slide the trailer tandem or add an axle, instead of finding out at a scale.
Know where every truck is and how it runs
High Point GPS fleet tracking records every trip, the distance run and engine hours for each truck, and sends maintenance reminders by distance or engine hours. Geofences around yards and customer sites show arrivals and departures, and IFTA distance is recorded by jurisdiction, so the paperwork that follows a heavy load is already done.
Get a quoteTips for a legal axle setup
Measure spacing from the centre of one axle to the centre of the next. A few inches can move a group into a different row of the bridge table.
Check the short groups first: the drive tandem with the steer axle, and the two tandems together. They fail more often than the whole truck.
Sliding the trailer tandem back lengthens the groups that include it, which raises their limit, but check the state's kingpin to axle rules too.
State limits can be higher on roads off the Interstate and some states have grandfathered weights. Confirm with the state before you rely on a number.
Bridge formula questions
- What is the federal bridge formula?
- The bridge formula is W = 500 × (LN ÷ (N − 1) + 12N + 36). W is the maximum weight in pounds on a group of axles, L is the distance in feet between the first and last axle of the group, and N is the number of axles. It applies to any two or more consecutive axles on the Interstate System, under 23 CFR 658.17.
- What is the maximum weight for a semi truck?
- On the US Interstate System the federal limits are 80,000 lb gross vehicle weight, 20,000 lb on any one axle and 34,000 lb on a tandem axle. The bridge formula can lower the gross for a truck whose axles are close together. Some states allow more through grandfather rights or permits, so check the state where you run.
- What is the tandem axle exception?
- Federal rules let two consecutive sets of tandem axles carry 34,000 lb each, 68,000 lb together, when the first and last axles of the two tandems are at least 36 feet apart. Without this exception, the bridge formula would allow only 66,000 to 67,500 lb on tandems spaced 36 to 38 feet apart, according to FHWA.
- What counts as a tandem axle?
- FHWA defines tandem axles as two or more consecutive axles whose centres are more than 40 inches and not more than 96 inches apart, and limits them to 34,000 lb on the Interstate System. Axles 40 inches apart or less count as a single axle, limited to 20,000 lb. Beyond 96 inches, the bridge formula sets the limit.
- Does the bridge formula apply in Canada?
- No. The bridge formula is a US federal rule for the Interstate System. In Canada, each province and territory sets its own axle and gross weight limits, and they can change with the season, such as during spring thaw. Check the rules of the province you drive in before you load a truck for a Canadian trip.